New products

Traxxas

Clutch bell (15-tooth)/5x8x0.5mm fiber washer (2)/ 5mm e-clip (requires 5x11x4mm ball bearings part #4611) (1.0 metric pitch)

Traxxas

Screws, 2.6x8mm countersunk machine (6)

Traxxas

Stub axle, (1)/ axle sleeve (1) Revo/Maxx (steel constant-velocity driveshaft)

Traxxas

Aluminum Hollow Ball Set

Traxxas

Steering and Throttle Servo horns (for non-Traxxas servos (Hitec, JR, KO, Airtronics))

Traxxas

Bumper, front/ bumper mount, front/ 4x10mm BCS (2)/ 3x25mm BCS (2)

Traxxas

Suspension arms, adjustable wheelbase left side (upper arm (1)/ lower arm (1))

Traxxas

Push rod (steel) (assembled with rod ends) (2) (black) (use with #5359 progressive 3 rockers)

Traxxas

Push rod (steel) (assembled with rod ends) (2) (use with long travel or #5357 progressive-1 rockers)

Traxxas

Half shafts, center (internal splined (3)/ external splined (2)) (plastic parts only)

Traxxas

Nuts, 2.5mm nylon locking (12)

Traxxas

Cover plates and seals, forward only conversion (Revo) (Optidrive blank-out plate, Optidrive sensor cover, shift fork cover) These seals cover all of the openings in the receiver box and transmission when the forward only conversion is installed in Revo.

Traxxas

Driveshaft, steel constant-velocity, Revo/Maxx (shaft only, 128.5mm)/ drive cup pin (1)

Traxxas

Drive cups, inner (2) Revo/Maxx (steel constant-velocity driveshafts)/screw pin, M4/15(2)

Traxxas

Tuned pipe, plastic (TRX 2.5, 2.5R, 3.3)

Traxxas

E-clips, 1.5mm (24)

Traxxas

Spacers, steel (JatoTwin-Spoke wheels, front) (4)

Traxxas

Screw pin, 2.5x18mm (6)

Traxxas

Header, aluminum (T-Maxx) (for rear exhaust engines only) (TRX 2.5, 2.5R, 3.3)

Traxxas

Ball bearings, blue rubber sealed (10x15x4mm) (2)

Traxxas

Ball bearings, blue rubber sealed (5x10x4mm) (2)

Traxxas

Primary gears: forward (28-T)/ reverse (22-T)/ set screw yoke pin, M3/12 (1)/ 5x10x0.5mm PTFE-coated washer (1)

Traxxas

Diff gear set: 13-T output gear shafts (2)/ 13-T spider gears (2)/ spider shaft (1)/ 6x10x0.5mm PTFE-coated washer (1)

Traxxas

Chassis braces, lower (black) (for long wheelbase chassis) (2)

Traxxas

Hanger, metal wire (for Resonator pipe in T-Maxx with long wheelbase)/ telemetry sensor wire hold-down clip

Traxxas

Wheel hubs, hex (steel)

Traxxas

Wheel hubs, hex (2)/ axle pins (2.5x12mm) (2)

Traxxas

Half shafts, long (heavy duty) (external-splined (2) & internal-splined (2))/ metal U-joints (4)

Traxxas

Half shafts, short (heavy duty) (external-splined (2) & internal-splined (2))/ metal U-joints (4)

Traxxas

Bellcrank posts, aluminum (2)/ steering link threaded rod (3x25mm)/ long rod ends (2)

Traxxas

Coupler, exhaust (siliconee)

Traxxas

Axle carriers/ steering blocks (2)

Traxxas

Chassis braces, lower (2) (black)

Traxxas

Screws, set (grub) 4mm (6) (with threadlock)

Traxxas

Pulleys, 15-groove (front/ rear) (2)/flanges (2)/ axle pins (2)

Traxxas

20-Groove Aluminum Pulleys

Traxxas

Pulleys, 20-groove (middle) (2)/flanges (2)/ axle pins (2)

Traxxas

Front Aluminum Pulley Shaft (blue-anodized, light-weight aluminum)

Traxxas

Pulley shaft, front

Traxxas

Pulley shaft, rear

Traxxas

drive hub, clutch/ pawl & pin (installed)/spring/ set screws (2)

Traxxas

Rear hub, 2nd/ snap ring

Traxxas

Gear, 1st (standard)(41-tooth)

Traxxas

Disc, brake/ hub, adapter/ 2mm pin

Traxxas

Pads, brake/ cap screws

Traxxas

Slide carb linkage set (throttle link, brake link, and hardware)

Traxxas

Screws, 3x10mm flat-head machine (hex drive) (4)

Traxxas

Engine mount, screws (Nitro 4-Tec)

Traxxas

Stub axles (2)

Traxxas

Tie rods/ upper camber rods (rear) (24mm turnbuckles) (4)/ draglink, 36mm (threaded rod)